Samsung Galaxy Note 3 SM N900S Lollipop Firmware Flash File Stock Rom

Samsung Galaxy Note 3 SM N900S Lollipop Firmware Flash File Stock Rom
Samsung Galaxy Note 3 SM N900S Lollipop Firmware Flash File Stock Rom

www.androidduniya.com reminds readers it will not be held responsible for any damage to the device during or after installation of Samsung Galaxy Note 3 SM N900S Lollipop Firmware using Odin. Readers are advised to proceed at their own risk because of hardware faults.

Initial Requirements to install Samsung Galaxy Note 3 SM N900S Lollipop Firmware

  1. Unzip the Odin .zip file and run/open the Odin3.exe file from the extracted files on your PC and install Samsung USB drivers.
  2.  Enable OEM to unlock (If applicable):
    • Firstly, Go to Settings » About phone » and tap “Build number” seven times to enable “Developer options”.
    • Secondly, Go back to the main Settings page, scroll to the bottom and select “Developer options” from there.
    • Thirdly, Under Developer options look for Enable OEM unlock checkbox/toggle and make sure you Check it or turn it ON.

Also Read: Samsung Galaxy J7 2016 SM J710MN Firmware Flash File 6.0.1 Stock Rom

How to Install Samsung N900S Lollipop Firmware

  1. Boot your Samsung Galaxy Note 3 SM N900S Lollipop into Download mode
    • Firstly, Switch off your phone.
    • Secondly, Press and hold “Home + Power + Volume down” buttons for a few seconds until you see a warning screen.
    • Thirdly, Press Volume Up on the warning screen to accept it and boot into Download mode.
  2. Once your device is in download mode, connect it to the PC with a USB cable. The Odin window on PC should detect the phone and show an “Added!!” message.
  3. Now, extract the .zipped Samsung Galaxy Note 3 SM N900S Lollipop Firmware file you have downloaded to get the Odin flashable.tar file inside.
     Skip this step if you already have a .tar file of the Samsung SM N900S Lollipop Flash File.
  4. Click on the AP tab on Odin window and select the .tar.md5 file from the Samsung Galaxy Note 3 SM N900S Lollipop Firmware file that you have downloaded or can download it from the given below Link.
     Note: don’t play with any other options on the screen. Only you have to connect your Samsung Galaxy Note 3 device and select the PA tab.
  5. Click the Start button on Odin and wait for it to finish the process. Once it has finished successfully, you’ll see a pass message on the Odin screen.
  6. Finally, the device will automatically reboot after Odin complete the flashing. Now disconnect your Samsung Galaxy Note 3.

Download

Related Firmware

Be the first to comment

Leave a Reply

Your email address will not be published.


*