Samsung Galaxy J3 Prime (Metro PCS) SM-J327T1 Flash File Firmware

Samsung Galaxy J3 Prime (Metro PCS) SM-J327T1 Flash File Firmware Stock Rom reminds readers it will not be held responsible for any damage to the device during or after installation of Samsung Galaxy J3 Prime (Metro PCS) SM-J327T1 Flash File Firmware using Odin. Readers are advised to proceed at their own risk because of hardware faults.

Initial Requirements:

  1. Unzip the file and run/open the Odin3.exe file from the extracted files on your PC and install Samsung USB drivers.
  2.  Enable OEM to unlock (If applicable):
    • Firstly, Go to Settings » About phone » and tap “Build number” seven times to enable “Developer options”.
    • Secondly, Go back to the main Settings page, scroll to the bottom and select “Developer options” from there.
    • Thirdly, Under Developer options look for Enable OEM unlock checkbox/toggle and make sure you Check it or turn it ON.

How to install Samsung Galaxy J3 Prime (Metro PCS) SM-J327T1 Flash File Firmware Stock Rom

  1. Boot your device into Download mode
    • Step1, Switch off your phone.
    • Step2, Press and hold “Home + Power + Volume down” buttons for a few seconds until you see a warning screen.
    • Step3, Press Volume Up on the warning screen to accept it and boot into Download mode.
  2. Once your device is in download mode, connect it to the PC with a USB cable. The Odin window on PC should detect the phone and show an “Added!!” message.
  3. Afterward, extract the .zip firmware file you have downloaded to get the Odin flashable .tar file inside. Skip this step if you already have a .tar file of the firmware.
  4. Click on the AP tab on Odin window and select the .tar.md5 file from the Flash File that you have downloaded or can download it from the given below Link. Note: don’t play with any other options on the screen. Finally, you have to connect your Samsung Galaxy J3 Prime (Metro PCS) device and select the AP tab.odin samsung installation method width=
  5. Click the Start button on Odin and wait for it to finish the process. Once it has finished successfully, you’ll see a pass message on the Samsung Odin screen.
  6. Finally, the device will automatically reboot after Odin complete the flashing. Now disconnect your device.


USA (T-Mobile): TMK-J327T1UVU1AQG1-2017072610423-7

USA (T-Mobile): TMK-J327T1UVU1AQF7-2017070710414-7

Note: Above all product names, logos, and brands are the property of their respective owners. Above all company, product and service names used on this Blog are for identification and learning purposes only.

Related Firmware

Share firmware

3 thoughts on “Samsung Galaxy J3 Prime (Metro PCS) SM-J327T1 Flash File Firmware”

  1. I tried to get around the frp on my Samsung Galaxy j3 prime and didn’t know what I was doing. End result, my phone starts and runs in “binary mode” allowing me access but not any kernal or lollipop. It still says the frp is on when it boots up but I need to know what firmware goes where and the process in which to properly update my phone please. It’s model Number is SM-J327T1

Leave a Comment