Samsung Galaxy J1 SM-J100Y Firmware Flash File Stock ROM

Samsung Galaxy J1 SM-J100Y,Galaxy J1 SM-J100Y ,firmware flash file stock rom,Samsung Galaxy J1 Firmware,Samsung J1 Firmware,J1 SM-J100Y Firmware,Samsung Galaxy J1 SM-J100Y Firmware,Samsung Galaxy J1 SM-J100Y Flash File,Samsung Galaxy J1 SM-J100Y Stock ROM,Samsung Galaxy J1 SM-J100Y Firmware Flash File Stock ROM ,samsung firmware,samsung flash file,samsung stock rom,Samsung J-Series Firmware
Samsung Galaxy J1 SM-J100Y Flash File , Samsung Galaxy J1 SM-J100Y Flash File , Samsung Galaxy J1 SM-J100Y Stock Rom




Samsung Galaxy J1 SM-J100Y Firmware Flash File Stock ROM

Androidduniya.com reminds readers it will not be held responsible for any damage to the device during or after installation of Samsung Galaxy J1 SM-J100Y Firmware using Odin. Readers are advised to proceed at their own risk because of hardware faults.

Initial Requirements:

  1. Unzip the Odin.zip file and run/open the Odin3.exe file from the extracted files on your PC and install Samsung USB drivers.
  2.  Enable OEM to unlock (If applicable):
    • Firstly, Go to Settings » About phone » and tap “Build number” seven times to enable “Developer options”.
    • Secondly, Go back to the main Settings page, scroll to the bottom and select “Developer options” from there.
    • Thirdly, Under Developer options look for Enable OEM unlock checkbox/toggle and make sure you Check it or turn it ON.

How to install Samsung Galaxy J1 SM-J100Y Firmware Flash File Stock ROM

    1. Boot your device into Download mode
      • Step1, Switch off your phone.
      • Step2, Press and hold “Home + Power + Volume down” buttons for a few seconds until you see a warning screen.
      • Step3, Press Volume Up on the warning screen to accept it and boot into Download mode.
    2. Once your device is in download mode, connect it to the PC with a USB cable. The Odin window on PC should detect the phone and show an “Added!!” message.
    3. Afterward extract the .zip firmware file you have downloaded to get the Odin flashable .tar file inside. Skip this step if you already have a .tar file of the firmware.
    4. Click on the AP tab on Odin window and select the .tar.md5 file from the Firmware that you have downloaded or can download it from the given below Link. Note: don’t play with any other options on the screen. Finally, you have to connect your Samsung Galaxy J1 device and select the PA tab.
    5. Click the Start button on Odin and wait for it to finish the process. Once it has finished successfully, you’ll see a pass message on the Samsung Odin screen.
    6. Finally, the device will automatically reboot after Odin complete the flashing. Now disconnect your device




J100YDXU0AOC1_J100YOPP0AOC1_4.4.4

FIRMWARE DOWNLOAD LINK 1

FIRMWARE DOWNLOAD LINK 2

J100YDXU0AQB1_J100YOPP0AQB1_OPP

FIRMWARE DOWNLOAD LINK 1

FIRMWARE DOWNLOAD LINK 2

Note: Above all product names, logos, and brands are the property of their respective owners. Above all company, product and service names used on this Blog are for identification and learning purposes only.

Related Firmware

Be the first to comment

Leave a Reply